What decides whether a timber project lasts
Building with landscape timbers is not hard, but it is unforgiving: the lumber is heavy and most mistakes are buried the moment the first course goes down. Each card opens a full guide, and more are added as the section grows.
Types of Landscape Timbers
Pressure-treated pine, cedar and redwood, used railroad ties, other reclaimed lumber, composite and concrete compared. Standard US sizes and weights, ground-contact ratings, the creosote question answered plainly, and rough costs.
Lumber & safetyTimber Projects
Raised bed heights and bracing, lawn and path edging, steps with even risers, built-in benches, low retaining walls and where the safe limit sits, plus smaller weekend projects and a timber count for each.
What to build, and its limitsInstalling Landscape Timbers
Moving heavy timbers without hurting your back, gravel base prep by project, drainage under and behind, laying out square, cutting a 6x6 cleanly in stages, and the ways to anchor timbers so they stay put through freeze and thaw.
Base, cutting & fasteningCare & Maintenance
What weathering is normal for each lumber, which treatments and stains are worth it, the quick yearly check, honest lifespans including termite country, common problems diagnosed, and swapping out a single rotten timber.
Care & lifespanWhat makes them so handy
Three reasons landscape timbers show up in so many American yards, and one thing to watch out for.
A weekend is plenty
A raised bed is a few cuts and a handful of timber screws. Three steps up a bank is a Saturday morning. No mortar, no curing time, and almost nothing you cannot undo in the first hour. See the projects.
One piece, many jobs
The same 8 ft timber becomes a vegetable bed, a mowing edge, a step riser, a bench or a low wall depending only on how you set it. Few other landscaping materials are that flexible. Sizes and weights.
Great for growing
A raised bed warms up sooner in spring, drains better than heavy clay around it, keeps mulch off the paths and puts the soil at a height that is easier on your back. The growing side.
Watch out for creosote ties
Most used railroad ties were treated with creosote, which is not recommended for food gardens, play areas or seating. New pressure-treated, cedar or composite timbers give the same look without it. Read the safety section.
A timber project, in the order the decisions come up
Six stages. Follow them in order and you will rarely have to pull anything apart.
-
Step 1
Decide what you are building
A bed, an edge, steps, a bench or a retaining wall. Each has its own sensible height and amount of prep, and retaining soil is the one with a hard limit and possibly a permit.
Compare the projects → -
Step 2
Choose the lumber
Ground-contact pressure-treated for most jobs, cedar or redwood where you want untreated wood around vegetables, composite if you never want to maintain it. Used railroad ties only well away from food, play and seating.
Which timber for which job → -
Step 3
Work out the count and the weight
Your timber count plus 10 percent for cuts. Then be honest about how a 70 lb 6x6 gets from the truck at the curb to the back of the yard.
Cost and quantity → -
Step 4
Prepare the base and the drainage
Call 811 before you dig. Then a compacted gravel base, level both ways, and clean gravel with a perforated drain pipe behind anything holding back soil. This is what keeps it square through frost heave and how long it lasts.
Base preparation → -
Step 5
Cut, seal the ends and fasten
Mark all four faces and cut in passes, brush preservative on every cut end, then screw the courses together with timber screws and pin the whole thing to the ground with rebar or posts.
Cutting and fastening → -
Step 6
Check it once a year
Twenty minutes in early spring with a screwdriver: probe the ends for soft wood, check fasteners, alignment and the drain outlet. That really is the whole maintenance routine.
The yearly check →
Work out quantities before you buy
Timbers are heavy and delivery fees add up, so a second trip is worth avoiding. The soil to fill a bed often costs more than the lumber around it.
Landscape timbers: the questions people ask first
Quick answers to the common questions. Each guide has a fuller set of its own.
Are old railroad ties safe to use in a garden?
Most used railroad ties were treated with creosote, a restricted-use wood preservative the EPA allows for industrial jobs such as rail ties and utility poles, not for home landscaping, and its guidance is to keep creosote-treated wood away from food, drinking water and frequent skin contact. Creosote ties also ooze tar in hot weather, stain concrete and pavers and smell strongly. Creosote ties are not recommended for food gardens, play areas or seating. For most backyard projects, buy new pressure-treated, cedar or composite timbers instead.
Can I use landscape timbers for a vegetable bed?
Yes, with the right lumber. Untreated cedar, redwood heartwood and composite are the safest-feeling choices because nothing has been added. Modern pressure-treated lumber uses copper-based preservatives rather than the old CCA (arsenic) treatment, which was phased out of residential lumber at the end of 2003, and many gardeners use it for vegetable beds. If you would rather be cautious, line the inside faces with heavy plastic and leave the bottom open. Do not use creosote railroad ties around food.
How many landscape timbers do I need for a raised bed?
An 8 by 4 ft bed one course high takes three 8 ft timbers: two full lengths for the long sides and one cut in half for the ends. Two courses take six, which is a popular height for vegetables. A 4 by 4 ft bed two courses high takes four. Add about 10 percent for cuts and round up to whole timbers.
How do you fasten landscape timbers together?
Use structural timber screws, typically 6 to 10 inches long with a hex or Torx drive, pre-drilled and driven through one timber into the one below, two per joint. That ties the courses together. Then drive 1/2 inch (#4) rebar down through the bottom course into firm, undisturbed soil, or fasten to posts set in concrete below the frost line, to hold the whole thing in place. Most projects need both.
How high can a landscape timber retaining wall be?
Up to about a foot is simple. From 1 to 2 ft you need a compacted gravel base, courses fastened together, deadmen or posts and real drainage behind. From 2 to 3 ft is borderline and worth having designed, and many localities require a permit and an engineered design for retaining walls over about 4 ft, or lower if there is a load such as a driveway above. Retained soil is very heavy and failures are dangerous, so check with your building department.
How long do landscape timbers last?
Pressure-treated timbers rated for ground contact typically last 10 to 20 years, cedar and redwood heartwood somewhat less in wet soil, composite 25 years or more, and concrete or stone effectively indefinitely. Drainage matters more than material: wood that dries out between soakings lasts about twice as long as wood sitting in wet ground. Termites are a factor in the South, so ground-contact treated lumber is the safer choice there.
Do landscape timbers need treating?
Pressure-treated faces do not, because the preservative is in the wood. What you must treat is every cut end, because cutting exposes untreated wood right where water collects. Brush on an end-cut preservative (copper naphthenate is common at home improvement stores). Untreated cut ends are the most common reason timber projects rot early, and it takes ten seconds to prevent.
What size landscape timbers should I buy?
Standard landscape timbers from a home improvement store are 8 ft long with two flat faces, fine for edging and low beds. For sturdier beds, steps and anything holding back soil, use pressure-treated 6x6s (actual size 5 1/2 by 5 1/2 in) rated for ground contact. Weight goes up fast: a freshly treated 6x6 can weigh 70 lb or more and a railroad tie over 150 lb, so plan on two people.
Shopping, building, or fixing something that has shifted?
If you have not bought anything yet, start with the lumber guide: new versus used railroad ties is the choice that comes with a real safety question. If the timbers are already stacked in the driveway, go straight to base prep and fastening. And if a bed has opened at the corners or a wall is starting to lean, the maintenance guide will help you work out why.